Our site is not fully compatible with Internet Explorer. We strongly suggest using Google Chrome, Firefox, Safari, or Edge.

FuelTech Dyno Day!

September 03, 2019

Want to learn more about how your FuelTech ECU can improve your racing program?

Check out our FuelTech Advanced Factory Training program to get your car dialed in and ready to race.

Our experts will guide you every step of the way, before setting foot on the track.

Want to learn more about how your FuelTech ECU can improve your racing program?

Check out our FuelTech Advanced Factory Training program to get your car dialed in and ready to race.

Our experts will guide you every step of the way, before setting foot on the track.

Want to learn more about how your FuelTech ECU can improve your racing program?

Check out our FuelTech Advanced Factory Training program to get your car dialed in and ready to race.

Our experts will guide you every step of the way, before setting foot on the track!



HUB DYNO / ADVANCED FACTORY TRAINING

FuelTech Mainline ProHub Dyno:

  • Capable of measuring over 5000 wheel horsepower, over 6000 engine horsepower.
  • Capable of simulating runs, leave off of 2-step limiter and do gear shifts, use nitrous, boost ramps
    under a pre-established elapsed time (ET) for the car.
  • Full electric dyno. Can hold the engine on any RPM, can do full RPM sweeps or step by step
    RPM for precise tuning.
  • No regular body straps required. The dyno is bolted to the car so there is no tire slip and is the
    safest way to test and tune a car.
  • Full CAN bus integration to FuelTech PowerFT ECU’s
  • FWD or RWD only. AWD vehicles must be converted before arrival.

Dyno Rental Only:

  • Dyno rental for FuelTech equipped vehicles only.
  • Requires experienced tuner.
  • When a FuelTech ECU is going to be installed, it can only have a single “pass” to be used as
    baseline after FuelTech conversion. $250 for the base pass, available only if full day already
    scheduled.
  • Minimum full day scheduling.
  • Max 2 vehicles per day.
  • One FuelTech employee to assist with dyno operation.
  • $1,500/day during the weekdays, $1,800/day during weekend/holidays.
  • Payment required upon scheduling. 10% cancellation fee applies if 5 days’ notice is not given.
    • $500/day for FuelTech trained employee to drive vehicle on the dyno - Recommended
    • Advanced support $250/hr (if applicable)
  • In cases that require clean-up, there will be a minimum fee of $50.
  • Hours of operation: 9:00am - 5:00pm EST

FuelTech Advanced Factory Training:

  • Includes above - Dyno Rental (Full Day) w/ FuelTech trained employee to drive vehicle on dyno
    • Bring your car or inquire about FuelTech vehicles available for the training.
  • Personalized one-on-one training based on your race program or specific requests such as:
    • New install - First map setup, base map generation, configure inputs and outputs
      settings, harness inspection and testing
    • FuelTech products operation and troubleshooting
    • FuelTech ECU tuning training
    • Advanced datalog analysis
    • Performance analysis
    • Racer mechanical parts validation and testing assistance (engine parts, transmission,
      power adder comparison)
    • Racing industry manufacturer product development and validation
  • Max 3 people per training
  • $2,500/day during the week, $3,000/day during weekend/holidays.
  • Payment required upon scheduling. 10% cancellation fee applies if 5 days’ notice is not given.
    • In cases that require clean-up, there will be a minimum fee of $50.
    • Hours of operation: 9:00am - 5:00pm EST



Also in Articles

FuelTech C8 Corvette Goes 9.017 at 153.13 mph | New World Record
FuelTech C8 Corvette Goes 9.017 at 153.13 mph | New World Record

September 21, 2021

They say timing is everything and that is certainly holding true for Anderson Dick and the FuelTech team as everything is starting to come together with their C8 Corvette project vehicle.

Read More

New World Record 1,350 WHP—FuelTech’s C8 Corvette Project Racecar Goes One Step Further, Again
New World Record 1,350 WHP—FuelTech’s C8 Corvette Project Racecar Goes One Step Further, Again

September 14, 2021

Anderson Dick, founder and CEO of FuelTech, has pushed the twin turbocharged LT2 engine platform into the mid-9s and was one of the first to eclipse the 1,000 WHP barrier.

Read More

How to make your project look even better - FuelTech SwitchPanel
How to make your project look even better - FuelTech SwitchPanel

August 26, 2021

FuelTech offers a full line of products to help make your racecar better and one of its most popular accessories is the FT SwitchPanel.

Read More