Our site is not fully compatible with Internet Explorer. We strongly suggest using Google Chrome, Firefox, Safari, or Edge.
 

Dual Power Driver Connector Kit

5011100562

Shipping Cut-Off:  USPS 9:30am EST / UPS 1:00pm EST

  • This kit is designed to make your install simpler and more serviceable if need be.
  • This kit contains:
    • 1X 4 way DTP kit (both sides)
    • 1X 4 way DTM kit (both sides)
    • 1X 2 way DTM kit (both sides)
  •  FT Dual Power Driver Manual



RECOMMENDED INSTALL INSTRUCTIONS


     

    4-way cable from DPD to DTP 4 pin

        • DTP 4 pin female
          • pin 1- Large red wire from DPD
          • pin 2- Large black wire from DPD
          • pin 3- Large blue wire from DPD
          • pin 4- Large white wire from DPD

     

        • DTP 4 pin male
          • pin 1- 12V from fuse (40A max)
          • pin 2- Battery negative
          • pin 3- eGate large red wire (motor +)
          • pin 4- eGate large white wire (motor -)

     

    2-way cable from DPD to DTM 2 pin

        • DTM 2 pin female
          • pin 1- Small red wire from DPD
          • pin 2- Small white wire from DPD

     

        • DTM 2 pin male
          • pin 1- ODD numbered yellow output (1, 3, 5, or 7)
          • pin 2- EVEN numbered yellow output (2, 4, 6, or 8)

     

    eGate sensor wires to DTM 4 pin

        • DTM 4 pin female
          • pin 1- Small red wire from eGate (5V+)
          • pin 2- Small black wire from eGate (sensor ground)
          • pin 3- Small white wire from (position signal)
          • pin 4- Small orange/yellow from eGate (temperature signal)

     

        • DTM 4 pin male
          • pin 1- Green/red stripe from ECU (5V+)
          • pin 2- Green/black stripe from ECU (sensor ground)
          • pin 3- Any available white input wire from ECU (position signal)
          • pin 4- Any available white input wire from ECU (temperature signal)

     

    NOTE- the small blue wire from eGate multi core wire is not used