About the product:

Fully programmable ECU with OLED display and VW hall effect distributor control.

Product Code: 2631

- 16x2 Characters OLED Display
- VW Hall effect distributor ignition control
- 1 ignition output to control single coil and distributor system
- 18 channel internal datalogger (FuelTech USB-CAN Converter needed – sold separately)
- Idle speed control by timing or by solenoid
- Plug and Play connection to Racepak IQ3 Dashboard *
- Built-in MAP/MAF Voltage Clamper

*Using integrated CAN port

*** $579.00 - FT250 w/o harness
*** $648.00 - FT250 w/ 10ft unterminated harness 

Product intended for off road race-only, ground vehicle use only. FuelTech is not responsible for any misuse of these products. Check with your local authorities regarding highway laws in your area.

Product Code: 2631

- Piston engine compatible (1 to 12cyl)
- Ignition and Fuel mapping directly on the ECU or through PC (Software FuelTech ECU Manager) *
- 8 input channels (IAT, ECT, Oil and Fuel pressure, O2 Sensor, TPS, Two-Step and RPM– not all sensors available at the same time)
- 2 injectors output that control up to 12 high impedance injectors
- 4 Auxiliary Outputs (fuel pump, fan, variable camshaft, etc.)
- Built-in MAP Sensor (87 psi)
- 5 Internal memory files
- Boost Control by RPM through N75 valve
- Progressive nitrous injection (wet/dry)
- Password protection
- Map backups on PC *
- Firmware update over the internet *
- Engine protection through 10 configurable alerts
- Time based rev limiter
- 10 or 20ft wire harness
- ECU Language according to your purchase region (no future language change is possible)
- Dimensions: 140mm x 80mm x 30mm

For detailed information, please check this unit instructions manual, available for download in our website.

* FuelTech USB-CAN Converter needed – sold separately





    FT250 EFI